Search Results for: buffer overflow
Juniper : Netscreen Remote Dial-UP VPN with AD Radius Authentication and route based VPN / tunnel interface
The following procedure explains how to set up a Juniper ScreenOS based firewall to accept Netscreen Remote Client VPN connections and authenticate users using Active Directory (Radius via Windows 2003 IAS or Windows 2008 NPS). We’ll assume that all traffic to from the client to the 192.168.0.0/16 networks needs to pass via the client VPN […]
Juniper Firewall ScreenOS Basics (CJFV)
ScreenOS Concepts & Terminology The following document is based on ScreenOS v5.4.0r7.0 – Interface = connection to a specific subnet. An interface is assigned an IP address only if firewall is operating in L3 mode. Default interface names can vary on different Netscreen devices. – Zone : logical grouping of subnets and interfaces. All devices […]
Cisco switch IOS cheat sheet
Reset to factory defaults : connect console (9600/8/None/1, no flow control) take out power cable press mode button (at the front), hold it, and put power cable back switch will go into recovery mode run : flash_init load_helper rename the config file : rename flash:config.txt flash:config.old run : boot When asked to enter the initial […]