In this post, I’m going to show you how to set up a Linux host (Fedora Core 9) and use it as a BGP enabled router.
In order to fully understand the setup & configuration, please have a look Read more
As explained in one of my earlier posts, ScreenOS supports a couple of ways to provide for dynamic routing. Today, I’m going to explain some basic implementations of BGP on ScreenOS. Unlike my post on OSPF, I won’t Read more
Scenario : you have 1 Juniper firewall, which has 2 internet connections : an expensive but reliable 4Mbit connection, and a fast, less expensive, but less reliable 20Mbit connection.
Goal : use the reliable connection for smtp traffic (1Mbit) Read more
OSPF is a link-state (dynamic) routing protocol that operates within an autonomous system. OSPF falls within the group of Interior Gateway Protocols. Devices that use OSPF will
A few days ago, I have posted some ScreenOS basics on this blog. Today, it is time to take it one step further and to look at setting up and especially troubleshooting IPSec VPN’s with Juniper Netscreen devices.
The following document is based on ScreenOS v5.4.0r7.0
– Interface = connection to a specific subnet. An interface is assigned an IP address only if firewall is operating in L3 mode. Default interface names can Read more
As far as I know, there are no free Management Packs available for monitoring Juniper/Netscreen firewalls with Operations Manager 2007. Catching snmp traps and syslog events seems to be the only "easy"/free way to monitor what is going on Read more
Today, I will explain the (easy) steps to set up a route-based IPSec VPN tunnel between a Juniper Netscreen firewall/VPN device and a remote Cisco device (such as Cisco ASA)
If you are looking for more generic information on Read more
As most of the bigger players in the firewall market, Juniper/Netscreen SreenOS based firewalls allow you to use/enforce/require authentication for various reasons :
In a default Read more
